win7点对点设置(国外英语资料).docVIP

win7点对点设置(国外英语资料) Laptop wireless docking - point-to-point connection to the Internet setup scheme Solution: One, two computers have wireless network CARDS (nonsense), and the driving installation is normal. Select one of the performance (CPU, memory) as a server and plug in the net. Make sure the server is on the Internet 4, set the IP address of the cable adapter for manual, dont automatically (some friends do not understand, words more here, 1) to check the IP address: start - Settings - control panel - network connections, right click on the local connection X - state, select the normal next to support page, see the IP address, write it down (such as mine, IP address: 192.168.1.88, subnet mask: 255.255.255.0, default gateway: 192.168.1.1), do not close; 2) set the IP address: choose normal page, click properties open the properties page, look at the middle, this connection using the following project to drag the scroll bar on the right (if any), next, double-left click on the Internet protocol (TCP/IP) or select it and click properties open (TCP/IP) properties page, select use the following IP address, will just write down the IP, in turn, fill out the preferred DNS server fill in the below default gateway (as I: 192.168.1.1), sure close a window, dont move, follow me down) 5, this step is one of the key, select local connection properties X window the last page of the advanced, see Internet connection sharing, among both check on the Settings inside I didnt change the default, if you dont trust all good, ok to close the window. (note: if no Internet connection sharing, because you have checked all the other on the computer network connection, make sure of it, and then remove the other network connection remove the Internet connection sharing, here is the same, do not say, ok remember point) 6, servers, wireless IP Settings, set the same IP address, IP address of the segment must not and cable, this is the key, otherwise, they cant do, the IP address of the gat