华为S9300 交换机QOS配置(国外英语资料).doc

华为S9300 交换机QOS配置(国外英语资料) Huawei S9300 switch QOS configuration The queue scheduling mechanism for the port of S9300 Each physical port has eight sending queues, the queue 7 has the highest priority, and the queue 0 priority is lowest. The sending port supports queue scheduling with PQ, WRR, and DRR, and supports hybrid scheduling of PQ + WRR and PQ + DRR. When mixed schedule, the PQ queue is scheduled to be dispatched first, and the highest priority queue is scheduled first when PQ is scheduled, and then the lower queue is scheduled. When the PQ queue is scheduled, the WRR or DRR queues are scheduled to be scheduled. For WRR and DRR queues, the queue guarantees the bandwidth first, then the WRR and DRR are scheduled according to the weight. How to support port speed limits The port speed limit is configured with QOS CAR under the port, and by configuring the flow strategy, the ACL rule convection is configured in the classifier to speed the speed limit. QOS CAR speed limit does not support the direction of the port, but the direction of the port speed and flow speed by port traffic flow direction issued policy or port is integer to the speed limit. The S9300 supports the access control, redirection, speed limit, port image of the direction Support for direction and access control. Support orientation flow redirection, not supporting redirection of direction. Speed limits for direction and orientation. Supports the image of orientation and direction. How do you do the flow configuration The flow rate is controlled by the rate of the output message, allowing the message to be sent at a uniform rate. The speed limit of the port can be achieved by the flow of the plastic. Flow shaping can be done for ports, or for priority queues. Enter the port view, the next flow of traffic: [Quidway] interface gigabitethernet 3/0/1 [quidway-gigabitethernet3/0/1] qos lr cir 100,000 [quidway-gigabitethernet3/0/1] qos queue 0, cir 50000 pir 100,000 Port maximum rate setting must be gre