华为交换机限制端口速率(国外英语资料).doc

华为交换机限制端口速率(国外英语资料) Huawei switches restrict port speed The speed limit of the switch is different! 2000_EI will enter the LINE - RATE (4) parameter directly under the port view! Port speed configuration Functional requirements and network description Port speed configuration Configure environment parameters The IP addresses of PC1 and PC2 are 10.10.1.1/24, 10.10.1.2/24 Network demand Configure the port speed limit on the SwitchA, limit the download rate of PC1 to 3Mbps, and limit the upload speed of PC1 to 1Mbps Data configuration steps S2000EI series switch port speed limit configuration process Use the line -rate command below the Ethernet physical port to speed the flow of incoming and incoming messages to the port. [SwitchA configuration] Enter the configuration view for port E0/1 [SwitchA] interface 0/1 Ethernet Limit the flow speed limit to 3Mbps in the direction of the port E0/1 [switch-ethernet0/1] line - rate outbound 30 Limit the flow speed limit to 1Mbps to the incoming direction of port E0/1 [switch-ethernet0/1] line - rate inbound 16 [supplementary note] The message rate limit is 1 ~ 127. If rate limit level value in the range of 1 ~ 28, the granularity of 64 KBPS rate limit, in this case, when the level set by N, the port limits on the rate of size N * 64 k; If rate limit level values within the scope of the 29 ~ 127, the rate limit of particle size of 1 MBPS, in this case, when the level set by N, the port on limiting the rate at which the size of N - (27) * 1 MBPS. The specific models for this series of switches include: s2008-ei, s201-ei, and s2403h-ei. S200-si and s300-si series switch port speed configuration process Use the line -rate command below the Ethernet physical port to speed the flow of incoming and incoming messages to the port. [SwitchA configuration] Enter the configuration view for port E0/1 [SwitchA] interface 0/1 Ethernet Speed limit to 6 MBPS for port E0/1 [switch-ethernet0/1] line - rate outbound 2 Speed limit to 3 MBPS in the