抽屉设计尺寸及规范(国外英语资料).doc

抽屉设计尺寸及规范(国外英语资料) Standardization and general design of furniture parts drawer After Chinas accession to the WTO, the furniture enterprise is faced with a positive development, especially the increasing of export products, as well as the stable and sustainable growth of gross domestic product. However, the current domestic manufacturers there are still some furniture is difficult to control the technical problems, such as 32 mm system concrete application and advantage of play is difficult to reflect all, lead to production technology is difficult to improve, hindered the enterprise to the pace of modernization, specialization and scale. If the standardization and universality of the furniture components are implemented, the enterprise can establish a standard zero, component library. The establishment of standard zero and component libraries can significantly increase production efficiency, improve material utilization rate and reduce production cost. The basis and goal of design The standardization of furniture components and general design is based on the first system on the basis of 32 mm, coupled with the double modulus, the partial products of special components must be matched with the special pitch. After for a bit, for example, mechanical properties of solid wood parts is better than the same specifications of the ordinary man-made plank, so the small size of some solid wood parts in the round bar tenon connection or (round bar tenon + hardware fittings) connection, can consider to use 20 mm pitch. And the orifice distance of the door hinges, some 52mm, some 48mm. They sure can only according to finalize the design the size of the hardware and use the corresponding pitch, the pitch of these special dedicated drilling equipment available to one or more complete. Universality refers to the performance of the same parts of the same product or different products that can be used at the time of assembly. Generally speaking, the completion of the 32mm system and