支架冲压模具设计(国外英语资料).docVIP

支架冲压模具设计(国外英语资料) Its all the same -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- Wip info Design of die stamping die Yao deqiang of guangdong institute of technologists (huizhou 516100) My unit undertakes a small stamping part of a factory in figure 1 The material of this part is 1Crl8Ni9Ti stainless steel, the middle shape of the clear L and two In view of the above situation, the minimum punch value of the material and the minimum of the shock The effect of 0.8 mm wide groove is to adjust the screw screw, which is not produced when the screw is made With the proof of the distance, the original eight process was changed to three formwork Born is loose. The u-bend Angle of 2.4 mm is less than 90. , M2 screw Sequence: the falling material is used to make the composite die. The bending pressure is used to compound the groove The center line to the curve is 1O. 3:20. Mm. If you use a single mode. Use the u-shaped transverse bending mold. Sequence mode production: the process of process is: the blanking of the blanking is an entire flat The blanking punch composite A bending of the bending of a bar, a bend of a curve. This process not only The mode is inverted composite (see figure 2). The upper mold is removed by push rod The efficiency is low, and it is difficult to guarantee the quality, especially in the flush mould It is expected that the waste will be leaking from the bottom of the mold, and the working principle When steel is easy to break. It can be replaced by chrome on the surface of 08F, but it should be Same as the normal mold. In the design, consider the strength of the type 16 and 19 The material is inelastic and adjust the screw, which is easy to loosen. And stability, take three steps on t