水晶头接法为什么要跳线(国外英语资料).docVIP

水晶头接法为什么要跳线(国外英语资料) Use twisted-pair cable clamp (of course you can also use other trimming tools) put one end of the five types of twisted-pair cable cut (its best to cut a meet the requirements of the length of the wiring cable), and then the cut, the end is inserted into the gap of cable clamp used for stripping, pay attention to the cable cannot bend, straight in, until to resist network cable clamp at the back of the gears, slightly closed line pressing pliers slowly rotating a circle (without having to worry about might damage the cable conductor inside the foreskin, because the wire stripping with a certain distance between each two blades, this distance is usually 4 to the diameter of the conductor), let the blade open twisted-pair cable protection rubber, unplug the rubber. This is shown in the figure below. Of course, you can also use a special wire stripping tool to peel the line. The length of the wire clamp is usually exactly the length of the crystal head, which can be used to prevent the strip from being too long or too short. It is not beautiful to strip the line too long, but also because the line cant get stuck by the crystal head, it is easy to loosen. Short, due to the presence of foreskin, stripping is too thick, not fully inserted to the bottom of the crystal head, crystal head pin cant contact with the cable core wires in good condition, that is not to make a success. Step 2: after stripping, you can see the four pairs of the double stranded wires, and you can see that each pair is different. Each pair of wound wire is made of a thread with a corresponding color and a white interwoven thread with a small color. The colors of all four colors are brown, orange, green and blue. Arranged side by side, 4 for the core word first and then to separate each pair of conductor (the note not cross line arrangement, that is to say, every adjacent to core), and according to the order of the unified (unified gives priority to color thread left and right of s