水泥混凝土路面面层施工工艺(国外英语资料).doc

水泥混凝土路面面层施工工艺(国外英语资料) Construction technology of cement concrete pavement Source: China bidding web date: [2006-9-1] Construction technology of concrete slabs for the installation to install templates, dowel bar, concrete mixing and transportation, concrete paving and vibrating, surface finishing, joint treatment, concrete curing and caulking. 1, install the template The template is suitable for use of steel stencils, curves and other non-standard parts, as well as small projects. Template should have no damage, have enough strength, medial and top and bottom surface should be smooth, level off, suitable straight, local deformation shall not be greater than 3 mm, when vibrating template transverse maximum deflection should be less than 4 mm, height should be consistent with the concrete pavement slab thickness, error is not more than plus or minus 2 mm, longitudinal seam template flat seam eye rod perforation should be accurate, tongue-and-groove seam is the enterprise department of breath or groove length error was plus or minus 1 mm steel template, wooden template plus or minus 2 mm. Set up a pass as a lever When the profile is installed, it is installed in the position of the transmission pole. When the concrete slab is poured continuously, it can use the reinforced support method. Namely garden reserved hole on the sealing board, so that the dowel bar through the sealing plate above the wooden or iron pressure cracks batten, dowel bar according to the location and spacing, inverted u-shaped groove at the bottom of the seam template make it, make the dowel bar resulting by the ends of the dowel bar fixed on the bracket, bracket foot in grassroots. When the concrete slab is not continuously poured, it can be used as a stick by means of the top block. At the end of the template of the lateral increase a positioning template, board according to the pass for pole spacing and stem diameter, drilling, the dowel bar through the end of the template hole, and until the la