电机机床夹具(国外英语资料).docVIP

电机机床夹具(国外英语资料) Noun explanation: Overpositioning: the phenomenon of a certain degree of freedom of the artifact being repeatedly restricted. Location reference: the benchmark used to determine the correct position of the workpiece on the machine tool or fixture. 3, 6 rule: when workpiece positioning, with a reasonable distribution of six bearing point contact with the workpiece positioning base phase to limit the six degrees of freedom of workpiece, determine the position of the workpiece completely, called six rule Location error; The maximum amount of variation in the processing dimension of the process procedure for the process process of the same batch of work. Group fixture: it is a special adjustable fixture that is designed and able to process a set of similar workpieces according to group principle. Non-coincidence error: the error that occurs when a reference is not coincident with the design (process). Full positioning: when processing, the six degrees of freedom of the workpiece are completely constrained by the position of full positioning. Self-locking: after the workpiece is clamped, the clamping device of the clamping device can still keep a reliable clamping when the function of manpower stops. This phenomenon is called self-locking. Packing: the process of making the workpiece properly in the fixture and intensifying the process. Why is clamping not equal to location? Answer: the action of external force is clamping workpiece cannot move, and right there in the workpiece in the fixture positioning is required to ensure, through the establishment of reasonable bearing point, The location of the workpiece is pressed close to the location support point to restrict the freedom of the workpiece and keep it in the right place by clamping. A, fills up the topic The clamped power source can be divided into manual clamping, pneumatic fixture, hydraulic jig, air hydraulic clamping device, electromagnetic fixture and vacuum clamp According to the characteristi