电脑网络端口号详解(国外英语资料).docVIP

电脑网络端口号详解(国外英语资料) 65535 but the average is a dozen. Here are some of the most common ports Ive looked for, and I hope that will help you Well Known Ports: from 0 to 1023, they are tightly bound to some services. Typically, the communication of these ports clearly indicates the protocol of a service. For example, port 80 is always HTTP communication. Registered Ports: 1024 to 49151. They are loosely bound to some services. That is, many services are bound to these ports, which are also used for many other purposes. For example, many systems handle dynamic ports starting around 1024. 3) Dynamic and/or Private Ports: from 49152 to 65535. In theory, these ports should not be allocated for services. In fact, machines usually allocate dynamic ports from 1024. There are exceptions: SUNs RPC port starts at 32768 With the port control Port: 0 Service: Reserved Explanation: used to analyze the operating system. This approach can work because in some systems 0 is invalid ports, when you are trying to use is usually closed port connection it will produce different results. A typical scan that USES an IP address of , sets ACK bits and broadcasts on the Ethernet layer. Port: 1. Service: tcpmux Note: this shows that someone is looking for the SGI Irix machine. Irix is the primary provider for implementing tcpmux, which is opened by default for tcpmux. The Irix machine is published with several default unencrypted accounts, such as IP, GUEST UUCP, NUUCP, DEMOS, TUTOR, DIAG, OUTOFBOX, etc. Many administrators forget to delete these accounts after installation. So HACKER searches the INTERNET for tcpmux and USES these accounts. Port: 7 Service: Echo Note: you can see a lot of people searching for the Fraggle amplifier, sending it to x.x.x.x.x.x.x.255. Port: 19 Service: the Character of the Generator Note: this is a service that only sends characters. The UDP version will respond to a package containing junk characters after receiving the UDP package. The TCP connection sends a data s