监理 继续教育20130527(国外英语资料).docVIP

监理 继续教国外英语资料) Problem 1 (2) GB 50369-50369 long oil and gas pipeline engineering construction and acceptance standard regulation, with cable trench buried pipelines installation, the minimum clearance (refers to two section of vertical projection interval) should not be less than (B). A. 0, 2 m B. 0, 3 m C. 0, 4 m D. 0, 5 m Problem 2 (2) GB 50369-50369 long oil and gas pipeline engineering construction and acceptance standard regulation, the end of the pipeline pressure testing, pigging with hygroscopic agent, dry mixture of pipe ends after discharge, methanol, glycol content of hygroscopic agent quality percentage is greater than (C) for qualified. A. 60% B. 70% 80% C. D. 90% Problem 3 (2) GB 50235-50235 industrial metal pipeline engineering construction and acceptance standard regulation, the tube cutting, the pipe surface should be smooth, no cracks, double skin, burrs, protruding sunken, shrinkage, slag, oxide, iron filings, etc. The skew deviation should not be greater than the diameter of the pipe (B), and must not exceed 3mm. A. 0.5% B. 1% 1.5% C. D. 2% Problem 4 (2) GB 50369-50369 long oil and gas pipeline engineering construction and acceptance standard gas pipeline detection rules, all of the welded joint should be 100% of the full circumference (D). A. liquid penetration detection B. Tensile strength test Full test Nondestructive testing Problem 5 (2) SH/T 3532-3532 code for construction and acceptance of the petroleum and chemical heat exchange equipment, pressure test should be done when the heat exchange equipment, must be approved by the (B) the safety technical measures, and safety supervision in the process of pressure testing. A. the head of construction unit technology B. the chief technology officer of the construction unit C. supervisor of the unit of supervision D. construction unit project manager Problem 6 (2) GB 50169-50169 electric device installation and acceptance specification for construction of grounding device of lightning r