通信电路(国外英语资料).docVIP

通信电路(国外英语资料) Power/level (dBm) : the output capacity of the amplifier, generally w, mw, dBm   level (dBm) = 10 LGW   5 w - 10 lg5000 = 37 DBM   10 w - 10 lg10000 = 40 DBM   20 w - 10 lg20000 = 43 DBM   from it is not hard to see, every double power, 3 DBM level value increases     gain (dB) : namely magnification, the unit can be expressed in decibels (dB).   : dB = 10 the lga (A power magnification)     insertion loss: when a device or component connected to the transmission circuit to increase attenuation, unit expressed in the dB.     selective: gain measures of frequency band and out-of-band radiation inhibition. -3db bandwidth is the same as the bandwidth when the gain drops 3dB. -40db, -60db.     standing wave ratio (return loss) : standing wave condition, wave abdomen voltage and the ratio of the nodal voltage pattern (VSWR)   enclosed: standing wave ratio, return loss table:   SWR 1.2 1.25 1.30 1.35 1.40 1.50   return loss (dB) 21 and 17.6 16.6 15.6 17.6     third-order pay adjustment: if there are two sine signals omega 1 and 2 because of the nonlinear effect will produce many omega intermodulation components, including 2 omega - omega 2 1 and 2 of 2-1 two omega omega frequency component is called the third order in the component, its power P3 and signal omega 1 or 2 omega power adjustable M3 says the third order.   the M3 = 10 lg P3 / P1 (dBc)     noise factor: generally defined as the output signal-to-noise ratio and the ratio of input signal to noise ratio, in decibels in practical use. Units with the dB.     coupling, coupling port and input port of the power ratio, unit in the dB.     isolation: the vibration or signal leak to other port power and the ratio of the original power of unit dB.     antenna gain (dB) : refers to the antenna to transmit power to a specified direction focus radiation ability. On the direction of the maximum of the antenna radiation field strength E and ideal homogeneo