高压断路器的接线方法 倒进线的弊病(国外英语资料).docVIP

低压断路器的接线方式 倒进线的弊端(国外英语资料) The connection of low voltage circuit breaker An overview, Circuit breaker is vertical or horizontal installation, the use of the circuit breaker panel nameplate word or identification parameters, will be at the top of the circuit breaker terminal as in line of power supply, also known as the power supply side, the circuit breaker at the bottom of the terminal as the connection end of the load, also known as the load side, this kind of connection mode, called the aspirant line; Instead, the power end of the circuit breaker is treated as a load, and the load is used as the connection mode for the power end. The typical form of matriarch Circuit breaker line is usually in line form, but is usually connected to the circuit breaker for installation. For example: the power supply is below the distribution cabinet, and the power supply line to the circuit breaker load is convenient. Also has a cabinet in the upper and lower two rows containing two or circuit breaker, the power supply into line in the middle part, introducing the upper and lower two or two rows of circuit breaker, respectively, for the next in line and the top line connection mode. There is also a special occasion, no matter what measures are taken to avoid the way down the line, in the classical form of the matriarch of the building electric, as shown in figure 1. The QF1, 1F2, and QF3, in figure 1, are the form of couplets, only two circuit-breakers at the same time, and must have a disconnection. In actual operation, the commonly used three lock two keys to ensure the reliability of the chain, such as HSW1 series intelligent universal type circuit breaker has this function, three sets of circuit breaker has the same lock, lock body can reliably tripping, three sets of circuit breaker can only be equipped with two of the same key, when the key inserted and unlock, institutions to operation of the circuit breaker and the breaker closing properly. The QF3 is not equipped with the