电动机变频切换工频的问题(外国英文资料).docVIP

电动机变频切换工频的问题(国外英文资料) Frequency conversion of motor frequency switching: 285 reward points: 0 | resolution time: 2011-7-6 15:34 | : anonymous The motor is driven by the frequency converter to the rated speed, and then switched to the operating frequency. Some of the reactions on the Internet say that there is a shock current. What is the reason? If I use frequency converter to increase the speed of the motor to close to the synchronous revolution and is greater than the rated RPM, at this time to switch on the power frequency, impact will not be current? The best answer is youre going to use the converter as a soft starter? As long as the switch must have impact current, just different size. Smaller than direct start. Ask you say yes, I want to send inverter when the soft starter, because the soft starter is bad for starting current control (more than 2 times the rated current), so want to use the frequency converter motor drag below rated revolution under the synchronous revolution, when the inverter disconnect, then the motor connected to the power frequency power supply. Because the motor has been driven to the rated number, the current will be hit by the power supply The question of whether the answer can be achieved is not only electrical, but also the operating condition of the pump. For example: the converter switch takes time (3 ~ 5s), how much will the RPM change? The drop is as large as a shock current (more than two times the rated current). When you are really doing it, you will refer to the number of simultaneous revolutions or the number of simultaneous revolutions, and then switch over three to five seconds ], regardless of how to load in the instant of switching power supply will have impact current, if it is not necessary to had better not switch, because the inverter working in electricity suddenly disconnect the load, under the condition of frequency converter is also easy to damage. It is necessary to ask the truth Answer this way your converter w