皇冠轿车故障维修实例(外国英文资料).docVIP

皇冠轿车故障维修实例(国外英文资料) The engine is running badly A crown JXSl33 car, which was driven by a sudden engine failure, the engine failure warning lights flashing on the dashboard. The car is fitted with ZJZ, the GE engine, which USES a pressure-sensitive electronically controlled gasoline injection system. The system is equipped with a self-diagnostic device with a fault warning light on the dashboard and a self-diagnosing socket near the engine. Normally, when the ignition switch is closed, the warning light is lit and the lamp is extinguished when the engine starts. The warning lights in the engines work show that the electronic control injection system has a malfunction. Place the throttle in the closed position, shift handle in the neutral position, then close the ignition switch, use a wire, connect TE1 and E1. At this point, the warning lights are not equal to the intermittent time, showing the failure code as 24. The relative information of the vehicle indicates that the inlet temperature sensor signal has trouble, which leads to the ignition timing and the idle speed. After inspection, the signal line of the inlet air temperature sensor is broken and the failure phenomenon is lost. Finally, the failure code memory is cleared. Example 2 engine cold starting difficulty A crown LSl2l car, equipped with a 2.0 L diesel engine, thermal car starter is normal, cold starting is difficult, especially on a cold winter morning, repeatedly with hot water, or other methods to preheating of cylinder block, the water temperature is at least more than 500 ℃ before starting. The fault is caused by the automatic control of the cold starter in diesel engine. In order to improve the cold starting performance, on the vehicle equipped with automatic control of cold starting device, it can be during cold start, automatic make cold start device increase fuel injection advance Angle, and ensure the engine work under fast idle after starting, in case the stall and rapidly rising. The device