美能达维修代码(外国英文资料).doc

美能达维修代码(国外英文资料) Fail to troubleshoot the maintenance data of the copy machine (fault code) On the meida copier... The content of the This site searches for more information about the maintenance code for the meida. EP3170 code 3170 code detection instructions The 3170 code tests show that formula one has been tested and can be done without preheating, and the photocopier counting device is not working (press clear/stop Stop); F2: charge high voltage output adjustment (factory setting), dont adjust (run 30 seconds, or clear/stop). F3: the lamp voltage set by manual mode, press the photocopy key to begin to scan and light the exposure lamp. (run 30 seconds, or press The clear/stop stop) F5: AE sensor base voltage set, press the photocopy key to start scanning and light the exposure lamp (run 30 seconds, or clea) R/stop); F6: factory Settings (end of scan) The F8 ATDC sensor adjusts the imaging device to work, and the developer agitates (running for 5 minutes, or by clear/stop) F9: factory Settings (run for 30 seconds, or clear/stop) Adjustment: 4-1. Adjust (1) (adjustment of the optical system) A - 0 set the focal length of the lens. A - 1 adjusts the lens and so on. A - 2 adjusts the reflector and so on. A - 3 adjust the longitudinal ratio (adjusted for scanning speed) A - 4, etc. A - 5 amplification of the head position of the image (in A magnifying way 200% like the head of the image) 4-2. (adjust the overlap width of black/color copy) B - 2 adjust the black/colored overlap (black developer) (the color of the color - black overlap) C0000 main motor failure. C0045 cooling fan motor failure. C004E power cooled fan motor failure. C0070 main plus powder motor failure. The c0210 image transfer voltage is not normal. C03FF adjustment mode 11 is not appropriate. C0500 preheat failure. The temperature of the C0510 is too low. The temperature of C0520 is too hot. C0650 scanning in situ sensor failure. C0B60 pagination switch motor failure. C0B80 mobile motor failure. C0F3