高档小区及别墅建筑群机电设备监控系统(外国英文资料).docVIP

高档小区及别墅建筑群机电设备监控系统(国外英文资料) Hw-gl - PF5000 delivers exhaust system applicability The air blower which is used for the delivery of wind and wind. Fire control fan shall be monitored. Function introduction Common centralized management control: can be grouped by the host to send control commands to the controller. Timing control, based on a pre-ordered time program. Low environmental interlock control: by carbon dioxide concentration of carbon dioxide and carbon monoxide or carbon monoxide sensor (increase 1 AI), on-site chain control. Fire system integrated locking control. Monitor content Monitor: fan hands/auto state, operating status and failure status; The fan accumulates the time of operation, and sends out the check signal. Control: the fan qi stops at the prearranged time program. Control the fans start-stop by carbon dioxide or carbon monoxide concentration. Line and equipment selection Hw-gl - PF5001:5 DI, 5 DO Hw-gl - PF5002:9 DI, 8 DO Hw-gl - PF5003:11 uis, 7 DO The DI and DO signals can be used with RVV2 * 1.0 Use RVVP3 * 1.0 * AI Interface requirements The operating status signal of the fan should be derived from the passive contact point of the contactor, which is normally open. The fault alarm signal of the fan should be brought out by the passive contact point of the thermal protection relay, which is always open. Low fan power/automatic switch should be set in the hand, if the field manual control in manual operation, automatic state by the remote control, hand/automatic state signal should be passive normally open contacts. The fan power box provides a remote control signal, the control fan qi/stop, this control signal standard is 220VAC, the contact current capacity is 3A. Power supply requirement: all control fan power cases should be set aside for power terminals (firewire, zero, geodesic) and should be taken from the same phase. Low all accused of fan power box should be set aside terminals, such as running state and fault alarm, automatic equipm