STM32 UART2程序.pdfVIP

USART1 程序很多，看看 USART2 程序。注意红色部分，首先要使能相关端口的时 钟。 因为 USART2 可以映射成不同的端口，所以要端口映射。 结合你自己的开发板，设置正确的映射口.(正点原子的是 PA03PA02.) STM32F103ZE 默认的 USART2 就是 PA03PA02，如果配置映射，USART2 端口是 PD05PD06 了。 程序在正点原子开发板 SRAM 中调试通过，开发环境 IAR5.30. void USART2_Initialise( u32 bound ) { GPIO_InitTypeDef GPIO_InitStructure;//I/O ú3 ê ˉ á11ì NVIC_InitTypeDef NVIC_InitStructure;// D 3 ê ˉ á11ì USART_InitTypeDef USART_InitStructure;//′ ú3 ê ˉ á11ì /* Enable the USART2 Pins Software Remapping */ RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA , ENABLE); RCC_APB1PeriphClockCmd(RCC_APB1Periph_USART2, ENABLE); /* Configure USART2 Rx (PA.03) as input floating */ GPIO_InitStructure.GPIO_Pin = GPIO_Pin_3; GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING; GPIO_Init(GPIOA, GPIO_InitStructure); /* Configure USART2 Tx (PA.02) as alternate function push-pull */ GPIO_InitStructure.GPIO_Pin = GPIO_Pin_2; GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP; GPIO_Init(GPIOA, GPIO_InitStructure); /* Enable the USART2 Interrupt */ NVIC_InitStructure.NVIC_IRQChannel = USART2_IRQn; NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 3; NVIC_InitStructure.NVIC_IRQChannelSubPriority = 2; NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE; NVIC_Init(NVIC_InitStructure); USART_InitStructure.USART_BaudRate = bound; //ò»°ãéèÖÃÎa9600; USART_InitStructure.USART_WordLength = USART_WordLength_8b;//×Ö3¤Îa8λêy¾Y¸ñê½ USART_InitStructure.USART_StopBits = USART_StopBits_1; //ò»¸öí ￡Ö1λ USART_InitStructure.USART_Parity = USART_Parity_No; //ÎTÆæżD￡Ñéλ USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;//Yá÷¿ØÖÆ USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx; //êÕ·￠Ä￡ê½