利乐包检查.ppt

TBA/jl – 宽封包材 纵封的外观 横封范围 横封外观 在转换期间宽封包材的辨识 宽封包材的栈板上有一个特殊的标签来分辨 宽封包材的纸卷上有一个特殊的标签来分辨 密封条改变了 包装盒的术语 包装盒的术语 检查周期 破坏性检查 非破坏性检查 折痕线 重叠 打印 重量 易拉贴的位置检查 表面 横封 (TS) – 样品的准备 横封 横封的评估 横封评估 横封评估 (续) 塑料结块 阻断的密封 阻断的密封 阻断的密封 纵封 (LS) 纵封 (LS) 易拉贴和纵封边缘的位置 纵封 (LS) 纵封的视觉评估 纵封撕开 总结记录保存 The Tetra Brik Sealings Both seals (TS LS) are judge by the same criteria bad and good. There are two kinds of bad seals too hot or too cold. Cold seals are also named blocked seals. In between above mention seals do we find a good seal. COLD GOOD HOT The cold and hot seals are the low and upper limit to be able to achieve a good TS or LS. Principle of ridge inductor sealing The pre- conditions to be able to achieve a good traversal seal is that the filler settings is according to recommendations in the MM-book and also that daily and weekly maintenance and care is done accordingly to the OM-book. The actual sealing procedure; 1. The jaws hits the package material tube and a hydraulic pressure is applied. 2. When the full hydraulic pressure is applied is the IH-pulse for some hundred milliseconds introduced. The high frequency makes that the electrons in the AL-foil starts to move and by that heats up the inner PE-layer so it melts together. 3. The hydraulic maintain during the cooling phase. For cooling utilises the ridge inductors, there the specified cooling water flows. After the cooling is finished is the package cut off from the tube and ending up in the final folder. Tear Down Test The tear down test is the test which should be used to be able to evaluate both longitudinal and transversal sealing. Tear down tests should be done though out the whole production with certain intervals and especially at following events; Start ups, also short stop re-starts Reel changes Strip Product changes. The results of these tests should be documented. The OM-book contains a chapter how to execute these tests. Suitable tools to perform a test are; Stretch-pliers. TP Spare part No.