1、精车应选用刀尖半径较大的车刀片(国外英文资料).docVIP

1、精车应选用刀尖半径较大的车刀片(国外英文资料) NC machining technology and programming questions Matters needing attention 1. please fill in your work unit, name and ticket number at the seal of the test paper 2. read the title carefully and answer the questions as required. Keep the volume clean and do not fill in the enclosed area 3. the examination time is 90 minutes Fill in the blanks (1-10). 2 points for each question. 20 points!) 1. CNC machine tools to undertake the driving and performing tasks for the system. 2. when choosing the cutting quantity of the rough car, we should first select the largest possible amount. 3. the numerical control system of the first generation NC machine tools is () a numerical control device. 4., cutting parts, the internal and external surfaces should be processed, should be used () method of processing. 5. CNC machine tools compared with ordinary machine tools, it can flexibly adapt to changes in parts, structure, shape, etc. (to achieve) processing. 6. the basic unit for pulse allocation in CNC systems is (). 7. precision CNC machine tools processing accuracy and positioning accuracy is generally determined by (). 8. in the cutting motion of general machine tools, there is only one movement. 9. as long as the servo system of NC machine tools is open-loop, there must be no () device. 10. CNC lathe can thread processing, the spindle must be installed (). Two, judgment questions (first ~ 30 questions). Fill the parentheses with the result of the judgment. Fill in the V right and wrong fill *. 1 points for each question. 30 points!) 1. high and low voltage switching circuit is characterized by high voltage charging and low voltage maintenance. () 2. the larger the rake angle of the general tool, the better it is for turning the softer material. () 3. when the ring distribution is achieved with hardware and software, the initial state of the circuit is the same. () 4. the reliability of AC servo drive system is higher than dc. () 5. software interpolati