在烤瓷牙制作中如何取一个肩台清晰的印模(国外英文资料).docVIP

在烤瓷牙制作中如何取一个肩台清晰的印模(国外英文资料) [discussion] how to draw a clear impression of the shoulder in the manufacture of the porcelain teeth It is self-evident porcelain teeth tooth preparation importance, but if you cant take out a clear and complete impression is all in vain, we introduce a shoulder can be removed, the gingival sulcus clear impression method In front of the tooth because of aesthetic requirements, usually for the gum shoulder. We can flush the gingival place according to the method for the preparation of porcelain teeth tooth shape. At this time in order not to damage gums, we first gingival, the shoulder is exposed, in the labial and buccal subgingival preparation to 0.5 mm, finally finishing complete tooth preparation. The gum line is still in the patients mouth. In order to get a perfect model, we put the washing teeth saliva off, slightly dry, pull the patients lips do not hold under the couch gums, ready to use modular materials: agar and alginate impression material. Then we pulled out the gum line, and we could see that the gum canal was open, so we quickly hit the agar into the gum sulcus and then used the alginate impression material to take the mold. At this point we can get a agar into the gum groove and a clear impression on the shoulder. This one must remember: first dry, then take the gingival, then die. That is, only when the gum line is taken, the gingival sulcus is open. Any blow or pressure can make the gingival canal open and the condition can not be given a perfect impression . -------------------------------------------------------------------------------- The introduction of the landlord has been more detailed. But Id like to add a few words: the gums should go in one direction, and if necessary, one and a half or two laps. In addition, the current material for better mold use is silicone rubber, agar and alginate impression materials are basically used on demanding metal crowns, or basically not. The preparation of porcelain teeth is: