构件计算公式(国外英文资料).docVIP

构件计算公式(国外英文资料) Calculating the volume of 2008-12-19 member 10:40:49| classification: budget | Tags: | font in Small subscription (1) basis 1. band Foundation (1) base volume of exterior wall = center length of exterior wall foundation * base cross section area; (2) the volume of the inner wall foundation = the net length of the base of the interior wall * the cross sectional area of the foundation and the overlap volume of the +T joint The overlap section of the T - shaped joint is shown here. V=V1+V2= (L x B x H) + L ride [bh1/2+2 (B-b/2 x h1/2 * 1/3)] =L take [b * H+h1 (2b+B) /6] Type: V - the volume of the overlap part of the T joint of the inner and outer walls; V1: a rectangular volume, such as T joint lap diagram shown in the upper beam, Shishi V1=0; V2 from two three and a half size rectangular pyramid, such as T joint lap diagram shown in the lower beam, Shishi V= V2; H: the thickness of the cuboid, without beam Shishi H=0; 2., independent foundation (concrete separate foundation and column on the basis of the surface boundaries) (1) rectangular foundation: V= * * width * height (2) ladder Foundation: V= sigma, various steps (length * width * height) (3) a square tapered base: V=V1+V2=H1/6 * A * B+ (A+a) (B+b) +a * B +A * B * H2 A cone based Icon Type: V1 - based part of the upper prism volume (M3) V2 - the volume of the lower rectangular part of the foundation (M3) A, B, or V2 on both sides of the bottom edge on both sides of the rectangular part length (m) A, B -- on the bottom side bevel on both sides (m) H1, part of the high table (m) H2 - the height of the rectangle at the bottom of the base (m) (4) cup-shaped foundation; Basal cup neck volume (M3) V3=abh3 Type: H3 - cup neck height V3_ - Cup groove volume (M3) V4=, h4/6+ [A * B+ (A+a) (B+b) +a * b] Style: H4 cup cup groove depth (m). The size of the cup foundation is shown in Figure 7 - 6: V=V1+V2+V3V4 Formula: V1, V2, V3, V4 for the above formula. 3. full house foundation (raft foundation) Beam type f