精确对刀方法(国外英文资料).docVIP

精确对刀方法(国外英文资料) Test cutting method: the workpiece and tool clamping, driving the spindle rotation, moving the tool head to the workpiece, try to cut an outer circle. Then keep the X coordinates unchanged, move the Z axis, the tool leaves the workpiece, and measure the diameter of the outer circle of the section. By inputting it into the cutters length in the corresponding tool parameter, the system will automatically subtract the diameter of the outer circle from the cutters current X coordinate, that is to say, to obtain the position of the X origin of the workpiece coordinate system. Then move the tool to try to cut the end of one end of the workpiece, in the corresponding tool parameters in the width of the knife input Z0, the system will automatically at this time the tool Z coordinates minus the input value, that is, the workpiece coordinate system Z origin position. - [sharing] CNC lathe how to tool? CNC lathe, tool setting How to set a tool for NC lathe? A: the lathe is divided into a cutter and a cutter, but the principle of the tool is the same. First, there is no cutter. Lathe itself has a mechanical origin, you usually try to cut the knife, ah, such as the outer diameter of the car after a knife, Z to exit, measuring the vehicle outside How much is the path, then find the number of the knife you use in the G screen, move the cursor to X, and enter X... As measured by the machine, youll know the location of the knife The nose position is the same as the inner diameter. The Z direction is simple. Just place each knife in the Z to touch a place, and then measure the Z0 In this way, all the knives are recorded and the machining zeros are determined within the workpiece movement (offshift), and any knife can be used to determine the original workpiece Point. In this way, the tool must remember to read the knife before setting the knife There is a more convenient way is to use the tool we know chuck, chuck diameter, tool diameter can touch input, the diameter