材料成分分析检验员培训月S.doc

质量技术监督行业职业技能鉴定 实训基地（广州） 材料成分分析检验员国家职业资格培训通知 各相关单位： 根据《劳动法》、《职业教育法》以及国家劳动和社会保障部2000年第六号令《招用技术工种从业人员规定》的文件精神，国家将逐步实行职业资格证书制度，在全社会建立学历证书和职业资格证书并重的人才结构。材料成分分析（化学检验）人员考核已经纳入国家职业资格管理体系，从事材料成分分析（化学检验）人员必须持证上岗的要求。为此：广电质量学院（信息产业部电子602计量站）特举办“材料成分分析检验员国家职业资格培训班”。具体安排如下： 一、培训目的 1.提高材料成分分析（化学检验）人员的专业水平。 2.使学员能达到国家劳动和社会保障部规定的检验误差分析和数据处理常用仪器分析技术企、事业单位中从事检验的人员；、培训费用级资格1元/人；中级资格1元/人；高级资格元/人0086-20202联系人：刘老师 电邮：liuzheng@  国家职业资格鉴定（计量、检测）培训公告 国家职业资格鉴定（计量、检测）培训公告 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge