贝氏体的表面凹凸定义的各个方面.pdfVIP

Scripta Materialia 47 (2002) 207–212 www.actamat-journals.co Aspects of the surface relief definition of bainite H.I. Aaronson a,b,*, J.M. Rigsbee c, B.C. Muddle b, J.F. Nie b a Department of Materials Science and Engineering, Carnegie Mellon University, Pittsburgh, PA 1521-3890, USA b School of Physics and Materials Engineering, Monash University, P.O. Box 69M, Vic. 3800, Australia c Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907, USA Abstract Criticisms of reports that ferrite laths have a sessile interfacial structure are refuted. A local lattice correspondence, achieved across coherent regions between interfacial defects, suffices to produce surface reliefs and martensitic crys- tallography [Prog. Mater. Sci. 42 (1997) 101]. However, formation of tent-shaped surface reliefs by monocrystalline laths/plates is inconsistent with martensitic growth. 2002 Published by Elsevier Science Ltd. on behalf of Acta Materialia Inc. Keywords: Phase transformations; Bainite; Martensitic growth; Diffusional growth 1. Introduction inite (though the ter mIPS was introduced later) [3,4]. 1 A martensitic transformation at the atomic In another paper in this Viewpoint Set on Bai- level is taken as proved by such evidence [3,4]. nite [1], three definitions of bainite [2] are sum- Here the SRE definition is further considered marized in the context of recent developments. through a discussion of three related and