百家著名企业选人标准.doc.doc

百家著名企业选人标准 序号 公司名称 选人标准 1 TCL集团有限公司 1．综合素质最重要， 2．不崇尚名牌 3．不迷信成绩 4．务实型的人最受欢迎 2 安捷伦科技有限公司 1．坚韧的毅力 2．沉稳的态度 3．学习能力至关重要 4．强调速度、专注与责任 3 杜邦中国集团有限公司 1．考察个人素质方面的情况 2．看重个人的职业操守 3．对英语能力有较高的要求 4．强调团队精神 4 海尔集团公司 1．2．5 三联集团公司 1．2． 、、、、： 6 上海夏星高科技集团有限公司 1．3．，4．5．、、、6．7 通用电气中国有限公司 1．，2． 8 西门子中国有限公司 1．、、2．3．：、、 9 厦门建发集团有限公司 综合素质和责任感 10 新希望集团 1．、、、、、、、、2．11 LG中国电子有限公司 1．LG电子的了解 2．，3． 12 北京北大方正电子有限公司 1．，2．：、、、 13 北京电子控股有限公司 1．2．3． 14 北京金元见电脑技术有限公司 1．、、2．．具有良好的修养 IBM中国有限公司IBM共同成长UI斯达康中国有限公司SMC中国有限公司K集团 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing su