监理考试大纲.doc.doc

2011-2012年度水利工程建设监理工程师 过渡考试大纲 中国水利加强水利工程建设招标投标、建设实施和质量安全管理工作指导意见安全生产许可证条例生产安全事故报告和调查处理条例安全生产违法行为行政处罚办法国家重大建设项目稽察办法关于加强建设项目安全设施“三同时”工作的通知大型重点险库项目除险加固建设管理办法水利工程建设重大质量与安全事故应急预案建筑施工企业安全生产许可证管理规定水利工程建设领域项目信息公开和诚信体系建设试点工作方案水利建设市场主体不良行为记录公告暂行办法水利建设市场主体信用信息管理暂行办法水利工程启闭机使用许可管理办法 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, constant support hangers, dampers, damper function,