卡套式接头安装方法(国外英语).docVIP

卡套式接头安装方法(国外英语资料)Hydraulic pipe joint standardThe most important part of the preloading of the assembly of the card tube joint (1), which directly affects the reliability of the seal. You typically need a dedicated preset. The smaller joints can be pre-installed on the tongs. The idea is to use a joint as the parent, and press the nuts and carcasses onto the pipe. There is a type of card, such as the type of pipe joint, the card type end straightway, and the three-way pipe joint. The author found that even the same manufacturer of a batch of goods, the several joint on the depth of the taper hole is often not the same, as a result, the leakage, and the problem often ignored. What is the right thing, the pipe end joint connection, the connection end of the corresponding pre-loaded with the same type of joint, such can utmost ground to avoid leakage problem. The end of the pipe should be flat. After the pipe saw, it should be smoothed on the tools such as grinding wheel, and removed the burrs, cleaned and then used with high pressure air. When preloading, the coaxial degree of the pipe and the joint body should be kept as far as possible. The inner blade of the ambassador card is inserted into the outer wall of the pipe. The card should not be visibly deformed. When the pipe connection is carried out, the assembly shall be tightened in accordance with the regulations. The tightening force of the phi 6-1 card is 64-1, 15n, 16 phi MMR 259n, and phi 18mm is 450n. If the card is badly deformed during preloading, it will lose the seal. (2) it is forbidden to add sealant and other fillings. Someone in order to achieve better sealing effect, apply sealant in the card case, the sealant was rushed into the hydraulic system, hydraulic components caused by Yin hole blockage failure. (3) when connecting the pipe, the pipe should be sufficiently deformed to prevent the pipe from being stretched. (4) when connecting the pipe, the side force should be avoided and the side force is n