数控车削复习题及答案(国外英文).docVIP

数控车削复习题及答案(国外英文资料) CNC turning review questions and answers.Txt if betrayal is a kind of courage, then acceptance of betrayal requires more courage. Love is a block, marriage is a mountain. Bricks are not many, there is a piece of spirit; the mountain is not high, Shou Shou on the line. I. judgment questions In the 1. FUNAC system, the last line of the subroutine ends with M30. (wrong) 2. point linear control system not only controls the accurate positioning from point to point, but also controls the path from point to point. (to) 3. radius interpolation with radius programming, when the arc corresponding to the center angle is greater than 180 degrees, the radius is negative. (to) 4. CNC lathe using G54 - G59 instruction programming, the program must be placed in the first program, otherwise perform the following procedures, the tool will press machine coordinate origin, which may cause a collision. (to) 5. CNC machine tool parts movement in the positive direction is to increase the workpiece and tool distance between the direction. (to) 6. usually in naming or programming, regardless of the machine, the workpiece is assumed to be stationary and the tool is moved. (to) 7., because the rough surface of the repeated positioning accuracy is poor, so coarse benchmark can only be used once. (to) 8. CNC machine tools in the process of processing, you can always adjust the spindle speed, but can not adjust the feed speed at any time. (wrong) The 9. G50 instruction is to set the workpiece coordinate system through the program, and only to establish the workpiece coordinate system, which is related to the tool cutter locus without any action. (wrong) 10. program segment G41, G01, X10, Y40, D02 for tool radius compensation. The G41 represents the right compensation for the tool radius; the D02 indicates the compensation number, and the amount of compensation should be stored in the numerical control system with the number corresponding to the radius offset register. (wrong)