桩基钢筋加工(国外英文).docVIP

桩基钢筋加工(国外英文资料) The pile reinforcement processing.Txt), to love song, listen, love the people, far see me laughing when you do not quite proud of it now this is what you play? This article is contributed by sunzhongshan73 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. * * high speed rail task Project unit project name, construction unit, date of disclosure, disclosure content: 1., technical requirements 1., technical requirements, bored piles, steel cage processing The guide book Contract No. **-1 * * * super bridge, DK187+000 to DK190+107.05, China Railway * * * * high-speed railway * * * work area, date, date, process DK187+000 ~ DK190+107.05, technical quality department Place of disclosure 1.1 according to the materials security materials, technology and quality department to provide the number and size of the design drawings and processing; 1.2 steel in the process of bending before straightening, and should comply with the following provisions: 1.2.1 steel surface grease, paint, cement slurry and struck with a hammer to peeling, rust etc. should remove puffiness net 1.2.2; must be straight and no local bending; reinforced after processing, the surface should not weaken the steel section scars; when using 1.2.3 cold drawn steel straightening, straightening elongation of I grade steel: not more than 2%, grade II and grade of not more than 1%. 1.2.4 bending of steel bars and end bending hooks shall comply with the design requirements. When the design does not meet the requirements, should meet the following requirements: rebar bending diameter equal to or greater than 5 times the diameter of the reinforcement, the provision of linear length of not less than 3 times the diameter of reinforcement, bending part of the round shun. The lap joint of 1.2.5 steel arc welding joint shall be pre bent, the pre bending length is 10 times as welded as that of single side, a