高炉炉衬厚度检测技术性能分析与改进算法研究 - 中国测试.pdfVIP

第41卷第9期 中国测试 Vol.41 No.9 2015年9月 CHINA MEASUREMENT TEST September，2015 doi院10.11857/j.issn.1674-5124.2015.09.027 高炉炉衬厚度检测技术性能分析与改进算法研究 1 2 1 杜正聪 袁 辛 强 袁 王 军 （1.攀枝花学院，四川 攀枝花 617000；2.民航新疆空管局，新疆 乌鲁木齐 830016） 摘 要院针对冲击弹性波法高炉炉衬厚度检测技术测试准确度相对较低的问题袁分析其影响因素袁提出相应的改进 方法遥 通过改进重复反射法提高反射时间的识别准确度袁通过多点激振/多通道激振消减周边环境噪声的影响袁通 过CDP重合法和NMO修正提高冲击弹性波波速的识别准确度遥 利用改进方法对高炉进行测试袁其有效性得以验证遥 关键词院高炉曰厚度检测曰冲击弹性波曰正常时差 文献标志码院A 文章编号院1674-5124渊2015冤09-0120-05 Performance analysis and improved algorithm research of blast furnace lining thickness detection technology 1 2 1 DU Zhengcong ，XIN Qiang ，WANG Jun （1.Panzhihua Univ.，Panzhihua 617000，China； 2.Xinjiang Air Traffic Management Bureau CAAC，Urumqi 830016，China） Abstract: An improved method has been presented in this paper in view of the relatively lower test precision of the impact elastic wave detection method for blast furnace lining thickness based on the analysis of the influencing factors of such low precision. The new method comprises the following aspects: the recognition accuracy of reflection time was improved by ameliorating repetitive reflection method，the influence of environmental noise was eliminated by multi-point excitation/multi-channel vibration，and the identification accuracy of impact elastic wave velocity was improved by CDP coincidence method and NMO correction. The effectiveness of this method has been proved by the test of the blast furnaces