Allegro指令介绍.ppt

Allegro操作界面简介 Component Placement Setting Design Constraints Routing and Glossing Copper Areas and Positive or Negative Preparing for Post Processing Component Placement Manual Placement Quick place Modifying Padstacks Tools – Padstack – Modify Design Padstack Creating a Library form a Design File – Export – Libraries Move Symbol Or Edit – Move 鼠线的表示方法 Display – Show Rats – On Display – Blank Rats – Off Setting Design Constraints Setting up Design Rules Standard (default) Design Rules Spacing Rule Set Physical Rule Set Design Constraints Add Areas Property Property Add , Change and Delete Setting up Design Rule Standard (Default) Design Rules Spacing rule set (1) Spacing rule set (2) Physical Rule Set (1) Physical Rule Set (2) Design Constraints Add Areas Property Property Add , Change and Delete 利用 Find by Name 利用 Bus Name 针对的物件不同,就有不同的Property Routing and Glossing Grids Adding Signal Connections Inserting Vias Options Form Options Form—Smooth Options Form—Bubble/Gridless Moving Etch with the Slide Option Deleting Etch Using the SPECCTRA Autorouter Grids Setup – Grids Adding Signal Connections and Inserting Vias Option Form Done -- 佈線停止,回到Idle狀態 Oops -- 取消前線段的動作 Cancel -- 取消前指令 Next -- 佈線暫停,改走其他線 Temp Group -- 宣告走bus or Group線訊號 Complete -- 結束bus or Group線訊號選入動作 Reject -- 當有兩個物件重疊在一起時,放棄現再選取, 可改選其他 Add Via -- 打貫孔 Finish -- 以同層自動走完未佈線斷 Snap Rat T -- 移動訊號T點的位置 Neck -- 窄線佈線,須依Physical Rule Set宣告 New Target -- 改定同訊號的佈線終點 No Target -- 尾段訊號不顯示 Swap Layer -- 走線換層(Act層換到Alt層) 須停在Drill Pad or Via上 Toggle -- 出線角度切換(先直在斜或先 斜在直) Options Form – Bubble Options Form – Gridless Moving Etch with the Slide Option Deleting Etch Using the SPECCTRA Autorouter Unconnected Pins Copper Areas and Positive or Negative Copper Area Images Creating a Negative Copper Area Creating a Positive Copper Area Crosshatch Copper Editing Copper Areas Editing Copper Areas--Options Copper Are