chapt01_Introduction理论力学 第一章 英文概要1.pptVIP

1 - * Rules for Using SI Units Plurals are used as required when writing unit names henries (H; henry) Exceptions; lux, hertz, siemens No hyphen or space should be left between a prefix and the unit name Megapascal (not mega-pascal) Exceptions; megohm, kilohm, hectare 1 - * Rules for Using SI Units The symbol should be used in preference to the unit name because unit symbols are standardized Exceptions; ten meters (not ten m) 10 m (not 10 meters) 1 - * Rules for Using SI Units When writing unit names as a product, always use a space (preferred) or a hyphen newton meter or newton-meter When expressing a quotient using unit names, always use the word per and not a solidus (slash mark /), which is reserved for use with symbols meter per second (not meter/second) 1 - * Rules for Using SI Units When writing a unit name that requires a power, use a modifier, such as squared or cubed, after the unit name millimeter squared (not square millimeter) When expressing products using unit symbols, the center dot is preferred N.m for newton meter 1 - * Rules for Using SI Units When denoting a quotient by unit symbols, any of the follow methods are accepted form m/s m.s-1 or M/s2 is good but m/s/s is not Kg.m2/(s3.A) or kg.m2.s-3.A-1 is good, not kg.m2/s3/A 1 - * Rules for Using SI Units To denote a decimal point, use a period on the line. When expressing numbers less than 1, a zero should be written before the decimal 15.6 0.93 1 - * Rules for Using SI Units Separate the digits into groups of three, counting from the decimal to the left or right, and using a small space to separate the groups 6.513 824 76 851 7 434 0.187 62 1 - * Rules for Using SI Units When a derived unit is obtained by dividing a base unit by another base unit, a prefix may be used in the numerator of the derived unit but not in its denominator Example; k a rate of a spring which stretches 20 mm under a load of 100 N K=100 N/20 mm=5000 N/m or 5KN/m never use k=5 N/mm 1 - * Conversions Between Systems o