光缆测试参数和测试方法(外国英语资料).docVIP

光缆测试参数和测试方法 Testing parameters and testing methods of optical fiber cable After the installation of the fiber optic cabling system, the transmission characteristics of the link need to be tested, of which the main test items are the attenuation characteristics of the link, the insertion loss of the connector, return loss, etc.. Below we have a brief introduction to the key cabling, physical parameters measurement and troubleshooting, maintenance and other aspects of the network. I. key physical parameters of optical fiber cable link Attenuation: 1. Attenuation is the decrease of light power in the transmission of light along the fiber. 2, the total attenuation of optical fiber network calculation: optical fiber loss (LOSS) refers to the output power of the fiber output Power out and the transmission to the fiber when the ratio of power Power in. 3, the loss is proportional to the length of the fiber, so the total attenuation not only indicates the loss of the fiber itself, but also reflects the length of the fiber. 4, fiber loss factor (alpha): in order to reflect the characteristics of optical fiber attenuation, we introduce the concept of fiber loss factor. 5. Measure attenuation: Because fiber is connected to light sources and optical power timings, additional losses are inevitably introduced. Therefore, in the field test, you must first test the instrument test, the reference point settings (that is, zeroing settings). There are several methods for testing the reference point is mainly these methods according to the link object test to choose, in cable wiring system, the fiber length of itself is usually not long, so the test method and test jumper connector will pay more attention on the method is more important, on this point, see. The constant wiring testing technology article Return loss: Reflection loss, also known as return loss, refers to the number of decibels relative to the input light at the fiber junction. The greater the return loss, the better the