LaunchPad(MSP430G2553)_官方例程概要1.doc

LaunchPad 官方例程（无修改） 一切皆为2012TI杯电子设计大赛 1. //****************************************************************************** // LaunchPad Lab2 - Software Toggle P1.0, // // MSP430G2xx2 // ----------------- // /|\| XIN|- // | | | // --|RST XOUT|- // | | // | P1.0|--LED // //****************************************************************************** #include msp430g2553.h void main(void) { WDTCTL = WDTPW + WDTHOLD; // Stop watchdog timer if (CALBC1_1MHZ == 0xFF || CALDCO_1MHZ == 0xFF) { while(1); // If calibration constants erased, trap CPU!! } // Configure Basic Clock BCSCTL1 = CALBC1_1MHZ; // Set range DCOCTL = CALDCO_1MHZ; // Set DCO step + modulation BCSCTL3 |= LFXT1S_2; // Set LFXT1 P1DIR = BIT6; // P1.6 output (green LED) P1OUT = 0; // LED off IFG1 = ~OFIFG; // Clear OSCFault flag BCSCTL2 |=SELM_1 + DIVM_0; // Set MCLK for(;;) { P1OUT = BIT6; // P1.6 on (green LED) _delay_cycles(100); P1OUT = 0; // green LED off _delay_cycles(5000); } } 2. //****************************************************************************** // LaunchPad Lab3 - Software Port Interrupt Service // // MSP430G2xx2 // ----------------- // /|\| XIN|- // | | | // --|RST XOUT|- // /|\ | | // --o--|P1.3 P1.0|--LED // \|/ // //****************************************************************************** #include msp430g2553.h void main(void) { WDTCTL = WDTPW + WDTHOLD; // Stop watchdog timer P1DIR |= BIT0; // Set P1.0 to output direction P1IES |= BIT3; // P1.3 Hi/lo edge P1IFG = ~BIT3; // P1.3 IFG cleared P1IE |= BIT3;