ccnp考试排错用的到.pdfVIP

NAT Client 1 and Client 2 are not able to reach the WebServer at 41. Initial troubleshooting shows that DSW1, DSW2 and all the routers are able to reach the WebServer. Configuration on R1 ip nat inside source list nat_pool interface Serial0/0/0/1 overload ! ip access-list standard nat_ pool permit ! interface Serial0/0/0/1 ip address 24 52 ip nat outside ! interfaceSerial0/0/0/0.12 ip address 52 ip nat inside ip ospf message-digest-key 1 md5 TSHOOT ip ospd authentication message-digest On Which device is the fault condition located? A R1 B DSW1 C R4 D R2 Answer: A The Fault Condition is related to which technology? A EIGRP B HSRP C BGP D NAT Answer: D What is the solution of the fault condition? A Under the interface Serial0/0/0 configuration enter the ip nat inside command B Under the interface Serial0/0/ 1 configuration enter the ip nat outside command C Under the ip access-list standar nat_trafic configuration enter the permit 55 command D Under the ip access-list standar nat_trafic configuration enter the permit 55 command Answer: C OSPF 认证 Client 1 is able to ping but not . Initial troubleshooting shows that R1 does not have any OSPF neighbors or any OSPF routes Configuration on R1: Configuration on R2: router ospf 1 router ospf 1 log-adjacency-changes log-adjacency-changes network area 12 network area 12 default-information originate always ! ! interfaceSerial0/0/0/0.12 point-to-point interfaceSerial0/0/0/0.12 point-to-point ip address 52 ip address 52 ip ospf authentication m