AT指令大全详解完整版（国外英文资料）.docVIP

AT指令大全详解完整版 I. General orders 1, AT+CGMI gives the identity of the module manufacturer. 2, AT+CGMM get module identification. This command is used to get the supported frequency band (GSM 900, DCS 1800) Or PCS 1900). When the module has multiple frequency bands, the response may be a combination of different bands. 3, AT+CGMR revised version of the software. 4, AT+CGSN access to the GSM module IMEI (international mobile device identification) serial number. 5, AT+CSCS select the TE feature settings. This command reports which TE is used on the ME of the status setting. ME The letters that can be converted to each input or display. This is for sending, reading, or writing text messages. 6, AT+WPCS sets the phone book status. This special command reports the status used by the TE phone book ME. ME then converts each input or displayed string letter. This is used to read or write a telephone book Export. 7, AT+CIMI get IMSI. This command is used to read or identify the IMSI of the SIM card (International Mobile signer) Knowledge. You should enter PIN before reading the IMSI (if you need PIN). 8, AT+CCID get the SIM card logo. This command causes the module to read the EF-CCID file on the SIM card. 9, AT+GCAP obtain ability table. (supported function) 10, A/ repeat the last command. Only the A/ command cannot be repeated. This command repeats the previous execution command. 11, AT+CPOF shutdown. This special command stops the GSM software stack and hardware layer. Command AT+CFUN=0 The function is the same as +CPOF. 12, AT+CFUN set the phone can. This command selects the functional level of the mobile site. 13, AT+CPAS returns the active state of the mobile device. 14, AT+CMEE report mobile device error. This command determines whether to allow or not to use the result code +CME ERROR: or +CMS ERROR: instead of the simple ERROR. 15 、 AT+CKPD small keyboard control. The simulation ME small keyboard executes the command. 16, AT+CCLK clock management. This command is used