Canbus诊断头功能说明V3.55（国外英文资料）.docVIP

Canbus诊断头功能说明V3.55 Current version: 3.55 In the absence of special instructions, the following send commands are sixteen decimal V2.7 default mode is 29Bit reverse program mode ----------------------------------------------------------------------------------------------- 05/25/2009 V3.51 Bobby.zhang 1. increase K_Line capture mode, increase inter byte time 2. increase the number of times the K_Line sends the test bus (5000 times) 3. delete the VPW PWM data length in normal mode as requested by the diagnostic group 4., interrupt group requires VPW PWM in receiving superior data, the length includes only data length, not the whole frame length. 5., host computer serial port (USART1), baud rate changed from 115200 to 512000 6. increase the reset mechanism in Wei Ming mode. 06/24/2009 V3.52 Bobby.zhang Increase the same data in PWM and send multiple functions in USB_Adapter Explain： When sending data in VPW PWM mode, you cannot send data to the USB_Adapter serial port. This will affect the VPW PWM sending data. OBD2 pin function: Pin 1 single line CAN has 5V, 12V two kinds of levels. Pin 2 VPW function Pin 2,10 is the PWM function Pin, 3,11, CAN, Bus functions Pin 4,5 grounding Pin, 6,14, CAN, Bus functions Pin 7 K_line function Pin 16 for power + Pin 8,9,12,13,15 has no function. Power feed back information 55, AA, 00020000800007, FF,, AA, AA, AA, AA, AA, AA, AA, AA,... ^ ^ ^ ^ ^ ^ ^ ^ Version 2 corresponds to version 2 Add read version command: FF, FF, FF, EE, 0856657200000000, 00 Reverse message: EE AA XX XX XX XX 800007 FF 08 AA AA Electrical feedback information on XX 1. control filtration Once the filter command is issued, the system automatically stops receiving and starts receiving after knowing that the set mode is set Initializing filter tables FF FF FF 0008000000000000 0000 Add software filter address FF FF, FF 0108, XX, XX, XX, XX, YY,, YY, YY, YY Both the 11 and the 29bit write the ID information directly in large order, such as: 07E7 is written as 000007