Pro-e NC 面和轮廓的加工顺序（国外英文资料）.docVIP

Pro-e NC 面和轮廓的加工顺序 Processing order of face and outline The processing sequence of face is usually applied to machining workpiece with end face milling cutter. The machined surface must be parallel to the * * plane. In machining, when calculating the tool path, the system will focus on the shape of the machined surface. Contour machining CNC systems are generally applied to rough machining of vertical and bevel surfaces. The machined surface shall consider the continuity of the tool path. In this chapter, the cutting surface and the end face of the machining sequence system are introduced. The result of the sequence will depend on the shape of the machined surface. For the machining order, this chapter describes how to set the order parameters to obtain the best machining tool path. Process Overview In this chapter, the example of the cover will be used as an example. We first open the source file of this mold, and then the outline order will be used to get rid of the excess metal outside the mold. First, the outline processing order will select the faces of the design die, and then Mill The (-------the, Surface, previous, exercise) will be selected only because of the desired results After performing the profile sequence command, in the machining process is the next step in the top mold internal planing surface face. Youll see how the surface processing order system automatically fills the selected surface. If only a small part of the actual surface is selected, the system will be viewed as the selected surface, worn throughout the mold, and continues to run the order to produce the processing order. This chapter will instruct the reader to change parameters when applying the profiling and facing commands. The reader is expected to change the command parameters as much as possible so that command parameters can be well mastered. Sample operation 1. start Pro/ENGINEER and open the file COVER.MGF. 2. open the file, as shown in figure 6-1. 3. close the reference plane