VISTA120快速编程手册（国外英文资料）.doc

VISTA120快速编程手册 Honeywell Security VISTA - 120 quick programming manual Set the 6160 programming keyboard address to 01 (because the new hosts keyboard address factory settings For: 00, not shown when initial power is added At the same time according to the 1, 3 boot key for 5 seconds, the keyboard display Addr=31 or Addr=00, according to the 01 input Keyboard green light, keyboard display ***DISARMED*** READT TO ARM When the keyboard address is 00, the keyboard may not work when the program is finished. Note: 6148 keyboard cannot be programmed Two 、 daily operation of the system 1, go out. Green light (READY) on all zones is not triggered, can go out, Enter user password 2. For example, the user password is 1234, out of 12342 deployment operation. Red light (ARMEO), said the system enters out deployment. Green light (READY) said the standoff was not bright line, trigger or address module failure, keyboard display FAULT XXX, look for the reason carefully. Note: many customers do not use the user password in actual use, but only use the installer code (4140) of the factory settings Cloth / Chefang operation, that is not good, prone to problems, such as: enter the maximum after deployment, cannot withdraw Anti. Therefore, it is strongly recommended that the user program at least one user password after the host program is complete (permissions 1 - 3) Class, using the user password) to operate the host defence work. 2, disarm No alarm system in the deployment period, enter the user password (e.g. 1234) 1, removal system, The alarm system in the deployment period, enter the user password (e.g. 1234) 1, disarm system repeat transmission; Clear alarm memory once. 3, after the deployment of bypass area The alarm system sometimes does not need to all area defense, then need to zone bypass undefended, to other areas Deploy troops for defence。 A user password input 6 XXX (anti code) zone bypass A user password 2 deployment system At this time, the alarm system (NOT READY) sect