mastercam(外国英文资料).docVIP

mastercam Basic two-dimensional drawing Includes creation of points and straight lines, arcs and circles, splines, rectangles, ellipses, and regular polygons. 1. to create, through the coordinate input method, Origin (origin), Center (Center), Endpoint (endpoint), Intersec (node), Midpoint (middle), Point (known points) and Last (end point), Relative (relative) to create the desired point. In Mastercam, you can create a variety of different points: create curve points, create the parameter type node spline curve, spline curve control points to create NURBS, create a dynamic point, create a po