核主泵轴密封节流管标定技术.pdfVIP

42 核主泵轴密封节流管标定技术 2017.№2 核主泵轴密封节流管标定技术 1,2 1,2 1,2 1,2 冯晓东 ，江 福 ，吕延光 ，杨立峰 （1. 黑龙江省核主泵工程技术研究中心，哈尔滨150066; 2.哈尔滨电气动力装备有限公司，哈尔滨150066） [摘 要] 节流管降压的准确值直接决定核主泵机械密封的运行条件，若降压后的压力过高会使轴密封失 效，将导致机械密封泄漏量增大，影响核主泵的安全运行。为了实现压降值的精确测量，本文通过对沿程 损失公式进行推导得出Q/ΔP1/2 与Q/×105 的近似线性关系，并应用于节流管标定试验，标定结果完全满足 规定温度和流量下的降压要求。通过与理论计算长度比较确定，由于节流管表面粗糙度不同，实际标定长 度与理论长度存在长度差，表明节流管的理论设计必须经过试验验证才能应用于工程。 [关键词] 核主泵；轴密封；节流管；标定 [中图分类号] TM623 [文献标识码] A [文章编号] 1000-3983(2017)02-0042-05 Calibration Technology ofThrottlePipeof Shaft Seal forReactorCoolantPump 1,2 1,2 1,2 1,2 FENGXiaodong ,JIANGFu ,LVYanguang ,YANGLifeng (1.EngineeringResearch Center ofRCP HeilongjiangProvince,Harbin 150066,China; 2.Harbin ElectricPower Equipment Co.,Ltd.,Harbin 150066,China) Abstract: The accurate pressure loss value of the throttle pipes determines the operating condition ofthemechanical seal for reactor coolantpump directly.The shaft sealwillbe failure ifthepressure is high after pressure loss, then the leakage of the mechanical seal will increase and it will affect safety operation of the reactor coolant pump.In order to measure the accurate value of the pressure 1/2 5 loss, we get the linear relationship between Q/ΔP and Q/×10 by deriving the frictional formula in this paper and apply it into the calibration test of throttle pipes. The calibrating results meet the pressure loss requirement well u