A313A313M-03不锈钢弹簧丝技术规范.pdfVIP

Designation: A 313/A 313M – 03 Standard Specification for Stainless Steel Spring Wire1 This standard is issued under the fixed designation A 313/A 313M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* 3.1.5 Type designation (Table 1), 1.1 This specification covers austenitic and age-hardenable 3.1.6 ASTM designation and date of issue, stainless steel round spring wire intended especially for the 3.1.7 Supplementary requirements for government procure- manufacture of springs. ment, and 1.2 The values stated in inch-pound units or SI units are to 3.1.8 Special requirements. be regarded separately as the standard. Within the text and NOTE 1—A typical ordering description is as follows: tables, the SI units are shown in brackets. The values stated in 2000 lb (1000 kg) Stainless Steel Spring Wire, cold-drawn Class 1, each system are not exact equivalents; therefore, each system bright finish, 0.032-in. (0.82 mm) diameter, in 100-lb (50 kg) 16-in. (0.4 must be used independently of the other. Combining values m) coils, Type 302 to ASTM A 313, dated ____. from the two systems may result in nonconformance with the 4. Ge