研华-9000触摸屏驱动安装向导概论.pdfVIP

Touchscreen Driver Installation • Introduction • Specification • Installation - for Windows 95/98 - for Windows NT - for Windows 2000/XP - for DOS A.1 Introduction The DMC-9000 Series’ optional touchscreen uses an advanced 8-wire resistive technology. It provides more accurate sensing capacity than other technologies. The touchscreen is specially designed for tough industrial environments, and has been approved to FCC Class B standards. A.2 Touchscreen Specification Electrical • Contact bounce: 10 ms • Operating voltage: 3.3 to 5 VDC typical • Sheet Resistance: 20 mA (max.) • sheet resistance: 350 ±22% ohm/square • Insulation Resistance: 20 M ohm@ 25 VDC. From screen to screen: ± 20% Durability • Point Activation Life: 1 Million activations on a single point with a 5/8 diameter silicone finger with a 350g load at 2 Hz • Character Activation Life: 100,000 characters written within a 20mm x 20mm area on the touch screen • Surface Finish Properties: Minimum 4H hardness. 2 Touchscreen Driver Installation Optical • Visible light transmission: 75% typical ( 74% @ 550 nm test) • Clarity: Clear Finish - 25% Antiglare Finish - 15% Sensor board • Chemical strengthened glass meets “4H” hardness standard Environmental • Operating temperature: 0 ~ 50° C (humidity 20 ~ 90% RH) • Storage temperature: -25 ~ 70° C (humidity 20 ~ 95% RH) A.3 Installation of Touchscreen Driver The touchscreen into the DMC-9000 Series provides a driver for use with Windows 95, Windows 98, Windows NT 4.0 or Windows 2000/XP. To facilitate installation of the touchscreen driver, you should read the instructio