机组性能偏离设计状态时循环水系统优化分析_张炜光.pdf

机组性能偏离设计状态时循环水系统优化分析_张炜光.pdf

  1. 1、本文档共5页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
第55 卷第3 期 汽 轮 机 技 术 Vol. 55 No. 3 20 13 年6 月 TURBINE TECHNOLOGY Jun. 20 13 机组性能偏离设计状态时循环水系统的优化分析 1 1 2 张炜光 ,叶学民 ,吴瑞涛 ( 1 华北电力大学能源动力与机械工程学院 ,保定 07 1003; 2 河北省 电力研究院,石家庄 050021) 摘要:实际运行中的机组一般会不同程度地偏离设计状态,由此导致循环水系统优化失真。以某300MW 机组为对 象,采用静态建模方法分别对汽轮机低压缸效率与凝汽器清洁系数下降的热力系统进行建模,分析了凝汽器主要 热力参数变化对凝汽器性能的影响,确定了循环水系统最优运行方式及经济运行区域图,并实例分析了循环水系 统优化前后对机组效益的影响。 关键词:静态建模方法;热力系统;偏离设计状态;循环水系统;优化运行 分类号:TK267 文献标识码:A 文章编号:1001-5884 (2013)03-0211-04 Optimization Analysis of Circulating Water System in a Unit Deviating Design Point ZHANG Wei-guang1 ,YE Xue-min1 ,WU Rui-tao2 (1 School of Energy Power and Mechanical Engineering ,North China Electric Power University ,Baoding 07 1003 ,China ; 2 Hebei Electric Power Research Institute ,Shijiazhuang 050021,China) Abstract :The practical performance of units is usually deviated from the design point ,which would distort the optimization of circulating water systems. For a 300MW unit ,the thermal system configuration under the efficiency decrease of low pressure cylinder and the reduction of condenser clean coefficient are respectively established using the steady state modeling software. The effects of thermal parameters on condenser performance are investigated and the optimized operating table and regulation scheme for the circulating water system are suggested. The comparison of economic benefit under four running modes is also analyzed. Key words :steady state modeling ;thermal System ;deviating design point ;circulating water system ;optimal operation 对循环水系统优化产生一定误差。 0 前

文档评论(0)

kehan123 + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档