第九章 钢框架带悬臂梁段拼接节点抗震性能参数分析.pdf

39 5 Vol. 39 No. 5 2010 9 Journal of China University of Mining T echnology ep. 2010 1,2 1,2 2 常鸿飞 , 夏军武 , 孙冬明 ( 1. , 221008; 2. , 221116) : 利用有限单元方法, 考虑材料的非线性, 分别对拼接等强型和拼接削弱型带悬臂梁 拼接 节点进行分析, 考察螺栓预拉力界面摩擦因数悬臂 长度螺栓孔形状梁端构造措施等因素 对2 类节点抗震性能的影响. 结果表明, 拼接等强型节点的抗震性能对上述设计参数几乎没有依 赖性, 而拼接削弱型节点的抗震性能则显著依赖于各参数的改变. 将预拉力由P 增大为 12P 或 将摩擦因数由03 增大为05 均造成节点塑性转动能力降低 50% 以上; 将悬臂梁 长度由500 mm 减为300 mm 造成滑移荷载降低205% , 增为800 mm 则造成螺栓不出现滑移; 梁端构造加 强引起节点承载力提高168%, 塑性转角提高175% . 因此, 高强螺栓预拉力界面摩擦因数梁 端构造措施是影响拼接削弱型节点抗震性能的关键参数, 在设计中需重点关注. : 带悬臂梁 拼接节点; 抗震性能; 参数分析; 有限元 : TU 392 : A : 2010) Parametric tudy of the Aseismic Capacity of a teel Frame Cantilever Beam pliced Joint 1, 2 1, 2 2 CHANG Hongfei , XIA Junw u , UN Dongming ( 1. tate Key Laboratory for Geomechanics Deep Underground Engineering, China University of Mining T echnology, Xuzhou, Jiangsu 221008, China; 2. chool of Mechnics Civil Engineering, China Universit y of M ining T echnology, Xuzhou, Jiangsu 221116, China) Abstract: A finite element method w as used preform nonlinear analysis of equalstrength and w eakstrength steel frame cantilever beam spliced joints. Bolt pretension, friction coefficient at the interface, cantilever beam length, bolthole shape and reinforcement of the columnbeam connection are examined. It appears that these parameters have a small influence on the capaci ty of the equal strength splice joint to dissipate energy. On the other hand, the w eak