模具英语翻译大全概要1.docVIP

1.? ? ? ? The undercut area where interfere with slide block need to be filled material to help the slide can move smoothly.（和滑塊干涉的倒勾請加料填平至滑塊可以順利滑動）2.? ? ? ? The thickening added too thick.(加肉太多)3.? ? ? ? The thickening area is too wide.（加肉面積太大）4.? ? ? ? Gate position is moved.(GATE位置移位)5.? ? ? ? The split line of slide block or the??area of slide.(滑塊拆的位置)6.? ? ? ? This area is hard to be filled due to the sharp feature(此處有尖角，填充困難)7.? ? ? ? The strength of this area is too weak and isn’t easy to get cold due to the steel too thin.8.? ? ? ? ( 此處鋼材太薄，強度不足而且不容易冷卻)9.? ? ? ? .The semicircle of cylinder avoids designing on slide block lest it will be pulled apart or cause drag mark.10.? ? ? ? ( 圓柱特徵要有一半圓不可以拆在滑塊上，以免粘滑塊造成拉白，拉斷.)11.? ? ? ? The part will be damaged if we make lifter in this area.12.? ? ? ? ( 此處做斜銷在作動時會削到成品肉厚)13.? ? ? ? This is critical surface where is not allow to add material.14.? ? ? ? ( 這個面是裝配面，不能加料)15.? ? ? ? This thick wall area might because sink mark,Please reduce some wall thickness to improve it.)16.? ? ? ? ( 此處料位太厚，會有縮水，建議減料改善)17.? ? ? ? Please confirm whether it is critical surface or not. Please confirm whether it is acceptable to has Slide split line if we have slide in this area.18.? ? ? ? （此面是不是外觀面，此處做滑塊的話會有結合線，是否可以接受）19.? ? ? ? Please confirm whether we can reduce material to the area where have undercut as indicated to have shut off on core and cavity side. No slide block and lifter to be made.20.? ? ? ? （此處有倒勾，能否減料，使公母模靠破，不做滑塊和斜銷）21.? ? ? ? Please confirm the issues of Parting line, Gate position...Etc otherwise the lead-time will be extended.22.? ? ? ? （請盡快確認這種拆模方式和結構，否則會影響模期）23.? ? ? ? The trim mark of the gate is not visual after open the top case if the gate position is designed like it24.? ? ? ? （GATE做在此處的話.蓋子打開後看不到GATE的修剪部位）25.? ? ? ? We would suggest to enlarging draft to help tool released.) 26.? ? ? ? 加大拔模角，以便脫模順利）27.? ? ? ? There are sharp edges if set the parting line at here, It will reduce the tool lif