管子拼接工艺.pdfVIP

1．适用范围 scope 本工艺适用于 SEVAN650 各种管路系统中，碳钢管、碳锰钢管子的制作。 This procedure is applicable to the steel pipes, carbon manganese steel pipes production of various pipeline system for SEVAN650 2 、准备工作 preparations 2.1 材料准备 Materials preparation 2.1.1 管子按图纸要求选用合适的管材 Selection of the pipes according to the requirements of drawings 2.1.2 根据管子的材料选用合适的切割方法。 Choose an appropriate method of cutting according to the pipe material 。 2.1.3 钢管的切割一律使用带锯、相贯线切割机完成，对于需要修正的管子通径小于 32mm 不允许使用气割进行，通径大于 32mm 的可使用气割完成修正。 Pipe should be cut with band saw, the intersection line cutting machine. For pipe(DN ≥ 32mm)which demand modifying allow to modifying with gas cutting. 2.1.4 管子切割后，管子端面和管子外表面的垂直度应符合下列要求： The vertical degree between pipe ends and the pipe outer surfaces should meet the following requirements: 表一 管子公称直径 mm 垂直度 Nominal diameter Vertical degree ≤100 ≤1 100-200 ≤2 200 ≤3 2.1.5 管子的内壁不允许有氧化渣和切割飞溅，切割面要全面进行清洁，清洁的长度从切割 面起不得小于 50mm。 The pipe inner surface is not allowed oxide slag and cutting spatter, cutting surface need a comprehensive cleaning, and cleaning length from the cutting face not less than 50mm. 2.2 根据图纸要求选用符合要求的校管附件。 Select accessories of pipe reshaping and positioning which meet the requirements of drawings. 2.3 管子的弯制 bending of pipe 2.3.1 根据管子零件图要求选用合适的弯模以及相关的模具（本海工产品弯曲半径为 3 倍的 管子外径） Select suitable bending modulus according to the pipe parts drawings.(Bending radius of three times the pipes outsider diameter) 2.3.2 管子弯曲成型后椭圆度为小于等于 7% Ellipticity ≤7% after bending 2.3.3 管子弯曲成型后管子的缩颈率不小于 95% Neck down rate ≥95% after bending 2.3.4 管子弯曲成型后，管子壁厚的减薄量为对应标准棺材壁厚负偏差的 20% The reduc