2011市政实务（2011 municipal practice）.docVIP

2011市政实务（2011 municipal practice） (a total of 20 multiple-choice questions, 1 points for each question, options for each question, only one of the most with 1), prestressed concrete pipeline should be set to the lowest point (A) A. B. C. exhaust hole drainage hole grouting hole D. overflow hole 2, heavy soil pile construction should not be used when the water jet construction method the (A) A. B. C. clay sand gravel stratum D. sand layer 3, the construction of bridge closure section is wrong (D) A. before closure should be concrete strength B. temperature observation and beam height and spacing of the cantilever end closure segment should improve the level of C. closure segment length should be 2mD. at the highest temperature, pouring 4 15m arch bridge is correct to say that (C) A. as the bridge width using the block method of pouring B. should adopt the method of piecewise C. pouring should be in support of arch foot at the beginning of the concrete pouring completed before the D. bridge 5, the dewatering project statement is correct (P 111C) is conducive to enhancing the strength of soil environmental safety B.C. A. precipitation construction, to recharge D.6, wet surface construction is correct to say that (D) A. should adhere to the mix, how much, how much pressure, shop to complete the number of B. rain not complete, as soon as possible to prevent rolling, rainwater infiltration C. day digging stick finish, complete, finished, leaving troubles. D. cement concrete pavement should be fast vibration, smooth and molding, 7, lime stabilized base construction is wrong (D). A. should be used in silty clay and clay plasticity index of 10~15, 1~3 should adopt new lime B. pulverized lime without digestion using C. directly block gray before using 2~3d digestion D. digestion lime particle size not greater than 20mm8, the temperature of the modified asphalt (B) paving temperature of 150 DEG A. grind, start temperature of 140 DEG B. paving temperature is 160 degrees, rollin