自己动手做连衣裙.pdf

EVERY BODY BODICE PATTERN Pattern Pieces: • 1A, 1B - Front Inset (2 Total) • 2 – Shoulder Strap • 3 – Bodice Front • 4 – Bodice Back • 5A Left/Right, 5B Left/Right – Skirt Back (4 total) • 6A Left/Right, 6B Left/Right – Skirt Front (4 total) • 7 – Interfacing Piecing Together the Skirt Pattern Pieces: Follow this schematic diagram to piece together the 5A, 5B pattern pieces. Use the same process to piece together the 6A and 6B pieces. 5A and 6A: © 2008 Emerald Light Productions. For personal use only. Do not duplicate or distribute . Page 1 5B and 6B: Interfacing: Fuse interfacing to wrong side of each matching fabric section, following manufacturer’s instructions. Contrast #1- Overlay: With right sides up, pin contrasting overlay to corresponding bodice front (3) and bodice back (4) fabric sections. Baste just inside the 5/8” (1.5 cm) seam allowances. Contrast #2- Overlay: With right sides up, pin contrasting overlay to corresponding front inset (1) fabric sections. Baste just inside the 5/8” (1.5 cm) seam allowances. Underlining: With right sides up, pin matching fabric sections to corresponding underlining sections. Baste just inside the 5/8” (1.5 cm) seam allowances and along pleat lines, leaving thread ends for easy removal. Inset and Bodice:  To make each pleat in front inset (1), on outside, crease along line of small circles. Bring crease to line of large circles. Baste. Baste across pleats.  For each shoulder strap, pin two shoulder strap (8) sections, right sides together. Stitch long edges, taking up a 3/8” (1 cm) seam allowance. Trim seam allowances.  Turn right side out. Press. Baste raw edges together.  On outside, pin each strap to upper edge of front inset, matching squares and having raw edges even. Baste.  Pin lining to