TI-TAS5404-Q1-26W汽车四路D类放大器参考设计.docxVIP

TI TAS5404－Q1 26W汽车四路D类放大器参考设计时间：2016-02-29 09:36:01?????? 作者：TI?????? 来源：中电网TI公司的TAS5404-Q1是用于汽车音响主机的四路D类音频放器,四路模拟输入,四路BTL输出,每路能从14.4V电源中向4欧姆负载连续提供26W输出或向2欧姆负载连续提供45W输出,THD+N小于1%,75dB PSRR.每路增益为12 dB, 20 dB, 26 dB, 32 dB.本文介绍了TAS5404-Q1主要特性,框图和主要应用电路及其材料清单,汽车四路D类放大器参考设计TIDA-00573主要特性,框图,电路图,材料清单和汽车音响主机框图与主要指标.The TAS5404-Q1 device is a four-channel class-D audio amplifier designed for use in automotive head units. The TAS5404-Q1 device provides four channels at 20 W continuously into 4 Ω at less than 1% THD+N from a 14.4-Vdc supply when used with the application circuit. The input is configured as an analog single-ended interface. The patented PWM topology of the device provides dramatic improvements in efficiency and audio performance over traditional linear amplifier solutions. The improvement in efficiency and audio performance reduces the power dissipated by the amplifier by a factor of ten under typical music playback conditions. The device incorporates all the required functions required by the OEM application. The built-in load diagnostic functions for detecting and diagnosing disconnected speakers help reduce test time during the manufacturing process.TAS5404-Q1主要特性:TAS5404-Q1 – Single-Ended InputFour-Channel Class-D Power AmplifierFour Analog Inputs, Four BTL Power OutputsTypical Output Power at 10% THD+N?26 W/ChInto 4 Ω at 14.4 V45 W/ChInto 2 Ω at 14.4 VChannels Can Be Paralleled (PBTL) for High- Current ApplicationsTHD+N 0.02%, 1 kHz, 1 W Into 4 ΩPatented Pop-and-Click-Reduction Technology?Soft Muting With Gain Ramp ControlCommon-Mode RampingPatented AM Interference AvoidancePatented Cycle-by-Cycle Current Limit75dB PSRRFour-Address I2C Serial Interface for Device?Configuration and ControlChannel Gains: 12 dB, 20 dB, 26 dB, 32 dBLoad Diagnostic Functions:?Output Open and Shorted LoadOutput-to-Power and Output-to-Ground ShortsPatented Tweeter DetectionProtection and Monitoring Functions:?Short-Circuit ProtectionLoad-Dump Protection to 50 VFortuitous Open